This Tube Expansion Joint is installed directly on the pipe ends. It is suitable for round or oval cross-sections. For square cross-sections, fixing strips must be used and the duct wall must be drilled.
In the event of negative pressure, it must be taken into account that the expansion joint bellows pulls inwards and narrows the flow cross-section. Support rings must be used in this case.
As the clamping point assumes the medium temperature, the maximum temperature is 350 °C. Up to sizes of Ø 700 mm to 800 mm, fastening is carried out using multi-part hose clamps. For larger diameters, flange fastening should be used due to the higher tightness.
Additional information
Downloads
General information: All information given in this Technical Information sheet represents our current level of knowledge and serves as information on our products and their respective scopes. It is not meant to ensure any particular properties of any product or the suitability of any product for any specific application, neither does it create any liability on our part.